IBM 8835 - Eserver 325 - 1 GB RAM, Руководство по установке опций

Страница: 45 / 62

Completing the installation
Complete the following steps to complete the installation:
1. Position the internal cables so they do not interfere with the cover installation.
Attention: Before sliding the cover forward, make sure that all the tabs on
both the front and rear of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
2. Position the cover on top of the server and slide it forward. Press down on the
cover latch. The cover slides forward into position. Ensure that the cover
engages the tabs at the front and rear of the server.
3. If you removed the bezel, position the bezel directly in front of the server and
press it into place so that the retention tabs snap into the holes on the top, right
side, and bottom of the server.
4. If you removed the USB option tray, insert it fully into the slot below hard disk
drive bay 1.
5. Install the server in the rack. For details, see the Rack Installation Instructions
that come with the server.
Note: Depending on the options that you installed, after cabling the server, you
might need to run the Configuration/Setup Utility program to update the
server configuration. For more information, see “Updating the server
configuration” on page 32 and the
User’s Guide on the IBM
Eserver
Documentation CD.
6. To attach peripheral devices and connect the power cord, continue with
“Connecting the cables”.
Note: If you installed a SCSI drive, check the LEDs to verify proper operation
after you reconnect the power cord.
Connecting the cables
This section provides basic information about attaching peripheral devices such as
a keyboard and pointing device to the server.
For detailed information about external options and how to connect them to your
server, see the documentation that comes with these options. For the location of
external ports and connectors on the server, see the
User’s Guide on the IBM
Eserver
Documentation CD.
Chapter 2. Installing options
31