IBM 8275, Руководство пользователя

Страница: 28 / 110

Terminal Interface - Telnet
Telnet console management can be performed through an Ethernet port (In-band
connectivity). You must configure an Ethernet IP address before using Telnet
console management (Refer to “Chapter 3. Configuring your 8275-416” on page 17
for initially configuring IP information for your 8275-416 .
You can use any Telnet application that emulates a VT100 terminal to establish a
Telnet Console management session. Up to five concurrent Telnet sessions are
supported. For security, the Telnet session can be automatically logged off after a
certain time of inactivity. You configure the time of inactivity from 0 to 60 minutes;
the default is 5 minutes.
The terminal interface is menu driven and can be used to manage the 8275-416
through the EIA 232 port or a Telnet session. For security, a log in userid and
password is required. Multiple userids and associated passwords can be created.
Two levels of access privileges are supported: read/write and read-only.
See “Appendix D. Interface Conventions for the Console” on page 83 for a
description of the terminal keys. You may need to configure your terminal
application to enable use of these keys.
See “Chapter 4. Using the Terminal Interface” on page 25 for a description of the
terminal interface panels.
SNMP-Based Management Interface
The 8275-416 has an SNMP agent that supports SNMP Version 1 which allows it to
be managed by any SNMP-based application (for example, Nways Campus
Manager which supports the MIBs that the 8275-416 supports). MIBs supported by
the 8275-416 are shown in Table 3.
Table 3. MIBs Supported by the 8275-416 .
MIBs Supported
MIB-II (RFC 1213)
Definitions of Managed Objects for Bridges (RFC 1493)
Figure 8. In-Band Connectivity
14
8275-416 User’s Guide