IBM 7331, Руководство по установке, Страница: 41 / 62

Step 10. At the end of POST, the library beeps for 1 second. The control panel
display shows the message in Figure 21:
Figure 21. Power On Selftest Complete Display
Power On Selftest Complete
, 3 seconds before the library resumes
operation.
Step 11. If any of the following exist, call the 8mm Tape Library service
representative.
The control panel display is blank.
The power-on indicator continuously beeps and blinks an error code.
The power-on indicator does not light.
The library does not beep.
Step 12. After POST is complete, wait for the library initialization to complete.
During the initialization operation The control panel display shows the
message in Figure 22:
Figure 22. Initializing Display
INITIALIZING
. With the library door locked, the picker and accessor
are initialized to a known state to permit safe movement.
Step 13. Upon successful completion of initialization, the library returns to the
mode of operation it was in before the library was powered off.
Step 14. Make sure the library covers are installed.
Step 15. If additional language support is required, refer to the 7331 and 3449
8mm Tape Library Model 3xx Operator Guide, GA32-0376, for
instructions on how to select the required language.
Step 16. You may now power-on the system unit for the library.
Note: After completing the 8mm Tape Library installation, store its publications
with your system documentation.
Chapter 2. 8mm Tape Library Installation
23