IBM 7331, Руководство по установке, Страница: 35 / 62

Step 9. Single Drive – Single Host SCSI Configuration
System Unit
Term inator
T
T
1
2
3
4
System
Adapter
SCSI Jumper
Tape Library
Backpanel
A
B
C
System-to-Device
SCSI Cable
RSCSI01-00
Figure 14. Single Drive-Single Host SCSI Configuration
Refer to Figure 14 and perform the following steps:
Step 1. Remove 2 screws at the bottom of the back cover and lift the cover
off the library.
Step 2. Make sure the SCSI jumper cable is installed across connectors 2
and 3 on the library back panel.
Note: With the SCSI jumper cable installed, the library is configured
as a single SCSI bus. The library and tape drive respond on
this bus.
Step 3. Make sure the terminator is installed on connector 4.
Step 4. Align the external SCSI cable with connector 1 on the library back
panel.
Step 5. Push in to seat the cable and tighten the thumbscrews (finger tight).
Step 6. Connect the other end of the SCSI cable to the system unit.
Step 7. Go to “Step 12. Connecting the Power Cables” on page 20.
Chapter 2. 8mm Tape Library Installation
17