IBM 7331, Руководство по установке, Страница: 27 / 62

Step 6. Installing the Rack Hardware and the Rack-Mounted 8mm Tape
Library Model 356
Use the following procedure to install the Rack Hardware and the Rack-Mounted
Model 356.
Step 1. If required, vary off the rack devices where the library will be installed.
Step 2. If required, remove rack front and rear covers where the library will be
installed.
Note: These instructions are written for the installation of a single
library into a rack that does not currently have a library
installed. If a library is already installed, or if two libraries are
being installed, modify the instructions as required to
accomplish the installation.
Step 3. Position right rail alignment pin on the front of the rail in the 4th hole
from the bottom in right front rack upright. Position also, the U-shaped
channel on back of rail around nut clip in the rear upright. See
Figure 6.
Figure 6. Rail Alignment and Installation
Step 4. At the front of the rack, install a screw
1
through rack upright and
into the threaded hole in the rail and tighten screw. See Figure 6.
Step 5. Repeat steps 3 through 4 of this procedure to install rail on the other
side of rack.
Chapter 2. 8mm Tape Library Installation
9