IBM 71412RU, Руководство пользователя

Страница: 62 / 102

4. Open the retaining clip on each end of the DIMM connector.
5. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the outside of the server; then, remove the DIMM from the
package.
6. Turn the DIMM so that the DIMM keys align correctly with the slot.
7. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM
has not been correctly inserted; open the retaining clips, remove the DIMM,
and then reinsert it.
Release latch
8. Open the memory-card retention levers on the top of the memory card.
Attention: When you move the memory card, do not allow it to touch any
components or structures inside the server.
9. Insert the memory card into the memory-card connector.
10. Press the memory card into the connector and close the small retention lever.
11. Wait 2 seconds and close the large retention lever.
12. Slide the orange release latch to the locked position.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 55.
Installing a microprocessor
The following notes describe the type of microprocessor that the server supports
and other information that you must consider when you install a microprocessor:
50
IBM System x3850 M2 and System x3950 M2 Types 7141 and 7233: User’s Guide