26
2.
Carefully insert the head of a flathead (–) screwdriver into the slot visible
along either side of the cable cover (a) and pry it off.
3.
Squeeze the sides of the hinge cover (b) and pull it off.
4.
Gently lift the stand cover (c) along the top and then slide it backwards
and off the stand.
5.
Remove the signal cable and the power cord from the monitor by
disconnecting the corresponding adapters. Carefully cut the plastic tie to
free the power cord and remove the screw holding the power cord
clamp.
6.
Lay the monitor facedown on a cushion and remove the six screws
holding the hinge mechanism on the monitor. Lift off the hinge and base
assembly.
7.
If you are installing an arm or wall-mounting device, follow the directions
included with the device. If you are just changing your cables, continue
with Step 8.
8.
Connect the signal cable and the power cord, then refit the power cord
clamp in its original screwpost.
9.
Slide the stand cover back on the stand.
10. Put the hinge cover back on, making sure that the straight side is at the
top.
11.
Insert the three tabs at the top of the cable cover into the slots in the
back of the monitor and push the cover into place.
To obtain the correct cables and/or to get further instructions on installing
them, call the IBM HELPCENTER at the above numbers or contact your
dealer, retailer, or other IBM authorized Servicer.
b
c
a
T84H_setup0926_final.fm Page 26 Thursday, October 5, 2000 8:45 AM
