IBM 5887, Установка

Страница: 17 / 96

Attention:
v
Attach an electrostatic discharge (ESD) wrist strap to an unpainted metal surface of your hardware
to prevent the electrostatic discharge from damaging your hardware.
v
When using an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is used
for static control. It does not increase or decrease your risk of receiving electric shock when using
or working on electrical equipment.
v
If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
4. If necessary, remove the filler panels to allow access to the inside of the rack enclosure where you
plan to place the enclosure. See Figure 1.
5. If necessary, open or remove the front and rear rack doors.
6. Face the front of the rack and work from the left side to complete the following steps:
a.
Make a note of the lowest EIA unit to be used for the enclosure.
b. Use tape, a marker, or a pencil to mark the top mounting hole (A) of the lowest EIA unit.
Figure 1. Removing the filler panels
Installing the 5887 disk drive enclosure or setting up a preinstalled 5887 disk drive enclosure
3