IBM 5594-1AX, Инструкция по установке и эксплуатации

Страница: 39 / 74

UPS connection: AX models
About this task
Note: Check that the indications on the name plate located on the back of the UPS
correspond to the AC-power source and the true electrical consumption of the total
load.
Note: The UPS charges the battery packs as soon as it is connected to the
AC-power source, even if the button is not pressed.
Procedure
1.
Connect the UPS input plug to the AC-power source.
2. Connect the loads to the UPS. It is preferable to connect the critical loads to the
Primary outlet group shown as
and the non-critical loads to either the
Group 1 or Group 2 outlets shown as . Group 1 and Group 2 outlets can be
programmed to shed loads as desired. For the 5594-3AX, 3kVA models, connect
any high-power device to the 30 A outlet.
3. To program shutdown of outlets during operation on battery power to
optimize the available backup time, check the in/out settings (described in
Table 1 on page 13).
What to do next
After the UPS is connected to the AC power source, eight hours of charging is
required before the battery packs can supply the rated backup time.
UPS connection: KX models
About this task
Note: Check that the indications on the name plate located on the back of the UPS
correspond to the AC-power source and the true electrical consumption of the total
load.
1
2
3
Chapter 3. Installation
23