IBM 5594-1AX, Инструкция по установке и эксплуатации

Страница: 28 / 74

Operation status Cause Description
On Battery
Battery LED is on
1 beep every 10 seconds
A utility failure has occurred
and the UPS is in Battery
mode. The UPS is powering the
equipment with the battery
power. Prepare your
equipment for shutdown.
End of backup time
Battery LED is blinking
1 beep every 3 seconds
The UPS is on Battery mode
and the battery packs are
running low. This warning is approximate,
and the actual time to shut
down might vary
significantly.
Depending on the UPS load
and number of Extended
Battery Modules (EBMs), the
"Battery Low" warning might
occur before the battery
packs reach 25 % capacity.
Display functions
Press the Enter ( ) button to activate the menu options. Use the two middle
buttons ( and ) to scroll through the menu structure. Press the Enter ( )
button to select an option. Press the button to cancel or return to the previous
menu.
Main menu Submenu Display information or Menu function
Measurements Load W VA / Load A pf / Output V Hz
/ Input V Hz / Battery V min /
Efficiency / Power usage
Control Load Segments
Outlet Group 1: ON / OFF
Outlet Group 2: ON / OFF
These commands overrule user settings
for load segments.
Start battery test Starts a manual battery test
Reset fault state Clears active fault (UPS restart required)
Restore factory settings Returns all settings to original values
Reset power usage Clears power usage measurements
Settings Local settings Sets product general parameters
Input/output settings Sets input and output parameters
On/Off settings Sets On/Off conditions
Battery settings Sets battery configuration
Fault log
Displays event log or alarms
Identification
UPS Type / Part Number / Serial
Number / Firmware release / Com. card
address
12
Installation and User's Guide