IBM 306m - eServer xSeries - 8849, Руководство пользователя

Страница: 35 / 74

If you have other options to install, do so now. Otherwise, go to “Completing the
installation” on page 30.
Note: If the server has a RAID controller or adapter, you might have to reconfigure
the disk arrays after installing hard disk drives. See the documentation that comes
with the adapter for more information.
To remove a simple-swap SATA drive from the bay, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
3. Pull the loops of the drive tray toward each other and pull the tray out of the
bay.
Installing a hot-swap hard disk drive
The server hot-swap models support either two SAS hard disk drives or two SATA
hard disk drives. The installation procedure is the same for either type of drive. The
illustrations in this procedure show SAS drives.
To install a hot-swap hard disk drive, complete the following steps.
Note: If you have only one hard disk drive, install it in the left drive bay.
Attention: To avoid damage to the hard disk drive connectors, make sure that the
cover is in place and fully closed whenever you install or remove a hard disk drive.
1. Read the safety information that begins on page v and “Installation guidelines”
on page 17.
2. Make sure that the server cover is in place and fully closed.
3. Remove the filler panel from the bay.
Attention: To maintain proper system cooling, do not operate the server for
more than 10 minutes without either a drive or filler panel installed in each bay.
Chapter 2. Installing options
23