IBM 306m - eServer xSeries - 8849, Руководство пользователя

Страница: 53 / 74

9. Save the configuration and repeat step 2 on page 40.
10. Move the clear-CMOS jumper block back to pins 1 and 2 and reinstall the
riser-card assembly and cover; then, disconnect all power cords and external
cables again.
11. Replace the server in the rack and connect the external cables and power
cords; then, turn on the server.
Using the SAS/SATA Configuration Utility program (hot-swap
SAS/SATA models only)
Important: A configuration conflict (error code 1801) might occur if SATA RAID and
SAS/SATA RAID are both enabled. If you are enabling SAS/SATA RAID, make sure
that the SATA RAID Enable option in the Configuration/Setup Utility program is
disabled (for more information, see “Enabling the Serial ATA HostRAID feature” on
page 43.
Use the SAS/SATA Configuration Utility program to configure hot-swap SAS or
SATA devices. The SAS/SATA Configuration Utility program is available on hot-swap
SATA or SAS models only.
Starting the SAS/SATA Configuration Utility program
To start the SAS/SATA Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt <<< Press <CTRL><A> for Adaptec RAID Configuration
Utility! >>> appears, press Ctrl+A. If you have set an administrator password,
you are prompted to type the password.
3. To select a choice from the menu, use the arrow keys.
4. Use the arrow keys to select the channel for which you want to change settings.
5. To change the settings of the selected items, follow the instructions on the
screen. Be sure to press Enter to save your changes.
SAS/SATA Configuration Utility menu choices
The following choices are on the SAS/SATA Configuration Utility menu:
v
Array Configuration Utility
Select this choice to create, manage, or delete arrays, add or delete a hot-spare
drive, or initialize drives.
v
SerialSelect Utility
Note: This choice appears on a hot-swap SAS or SATA system only. It does not
appear on a simple-swap SATA system.
Select this choice to configure the controller interface definitions or to configure
the physical transfer and SAS address of the selected drive.
v Disk Utilities
Select this choice to format a disk or verify the disk media. For SAS disks, you
can also turn on the indicator LED on the disk, set the disk to be bootable,
change the write cache settings, or set the connection rate. Select a device from
the list and read the instructions on the screen carefully before making a
selection.
Chapter 3. Configuring the server
41