IBM 306m - eServer xSeries - 8849, Руководство по обслуживанию

Страница: 114 / 142

a. Squeeze and hold the bladder of the tool; then, place the suction cup on
the microprocessor and release the bladder.
b. Using the tool, carefully lift the microprocessor straight up and out of the
socket, and place it on a static-protective surface.
c. Squeeze the bladder of the tool to release the microprocessor from the
suction cup.
10. If you are instructed to return the microprocessor, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the microprocessor
To install the replacement microprocessor, complete the following steps:
1. Make sure the microprocessor bracket frame and release latch are both fully
open.
Attention: The microprocessor contacts are fragile; handle the
microprocessor very carefully.
2. Align the microprocessor with the socket (note the alignment mark and the
position of the notches); then, carefully place the microprocessor on the
socket, close the microprocessor bracket frame, and close the microprocessor
release latch.
Note: The microprocessor fits only one way on the socket.
3. If you are installing a new heat exchanger assembly, peel off the protective
backing from the thermal material that is on the underside of the new heat
exchanger. If you are reinstalling a heat exchanger assembly that was
previously removed, see “Thermal grease” on page 99 for instructions on
replacing the contaminated or missing thermal grease; then, return here and
continue with step 4.
4. Make sure that the heat-exchanger assembly release latch is fully opened.
98
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide