IBM 220, Руководство по техническому обслуживанию аппаратной части

Страница: 79 / 178

Installing options
71
Installing a non-hot-swap hard disk drive in bay 5, 6, or
7
To install a non-hot-swap hard disk drive in bay 5, 6, or 7, do the following:
1. Read the information in “Preinstallation steps (all bays)” on page 69.
2. Turn off the server and peripheral devices, and disconnect all external cables and
power cords; then, remove the cover (see “Removing the side cover” on page 59
for details).
3. Remove the support bracket assembly (see “Removing the support bracket
assembly” on page 61).
4. Rotate the drive cage upward. If the server has a hard disk drive installed in the
drive cage, disconnect the cables from the rear of the drive.
5. Remove the plastic bag that contains the drive rails and screws from inside the
drive cage.