© Copyright 2010 LOTRONIC SA
6
14. INPUT
FADER
Controls individual source levels for CH1-2 in the mix.
15. FADER
START
Activation allows you to start the CD players from your crossfader. Travel from left to right will start
the right CD player and pause the left CD player.
16. REPLACEABLE
CROSSFADER
Achieves clean segues between the two input channels. Hard left selects channel 1. Hard right
selects channel 2. With the crossfader centered, both assigned channels are live. Use the
crossfader for fast and seamless segues from one selected channel to the other.
CONNECTION:
17.
AC
CORD
Used this cable to connect the AC mains power to the unit.
18. POWER
BUTTON
Press the power switch to turn the unit on. To switch the POWER off press the POWER switch
again.
19.
GND
Grounding lug for turntable connection. Always use this connection when using turntables (your
turntable cable should have a grounding wire).
20. LINE/PHONO INPUT SWITCH
Use this to allow either line level or phono level equipment to be plugged into your channel inputs.
When phono input is selected, your signal is fed directly to the high quality RIAA phono pre-
amplifiers. Line level sources will overload the sensitive phono pre-amps and will sound very bad,
so always be sure to toggle the line/phono switch over to the line before connection of line sources.
21. INPUT
Plug the line level device such as tape deck or additional CD player here.
22. DJ
MIC
Plug XLR type microphone plug in here.
23. MIC
INPUT
Plug ¼” microphone plug in here.
24. STEREO
MAIN
OUTPUT
Unbalanced RCA connectors controlled by the master fader.
