Ibiza E-SPOT100, Руководство пользователя

Страница: 6 / 30

MANUAL - E-SPOT100
6
Code: 16-2099
SETTING UP A DMX SERIAL DATA LINK
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the con -
troller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
MASTER/SLAVE FIXTURE LINKING
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the
input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the
output as stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initial
-
ized for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow
may also require a slave setting. Please consult the ‘’ Operating Instructions» section in this manual for complete
instructions for this type of setup and configuration.
OPERATING INSTRUCTIONS
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
MENU MAP
Press the <MODE> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN>
buttons to navigate the menu options. Press the <ENTER> button to select the menu function currently dis -
played or to enable a menu option. To return to the previous option or menu without changing the value, press
the <MODE> button. After a few seconds, the LED Display will back during operation until another button is
pressed.
DISPLAY EXPLANATION
Addr A001-A512: DMX Address 001-512
CHnd 15CH: DMX Channel
SLnd DMX/Auto/Sound: Running Mode
Pan YES, NO: Pan Reverse
Tilt YES, NO: Tilt Reverse
SEne 0-100: Sound sensitivity
LED Backlight ON, OFF
DISP YES, NO: Display reverse
TEMP XXX: Device’s temperature
Ver V100: Software Version
Faet YES, NO: Restore to factory set
OFFSET:
In the Main menu, press ENTER for 5 seconds to access the Offset MENU
UP DOWN MENU ENTER
8.8.8.8.