©Copyright Lotronic 2013
IBIZA1000
3
Sound Activation
The change of the laser pattern is controlled by sound. That means the rhythm of the sound controls the change of
the laser pattern. Turn the sensitivity knob in the clockwise direction to increase the fixture’s sensitivity to sound,
turn the knob in the counterclockwise direction to decrease.
AUTO
Auto cycles the built-in programs without being controlled externally.
DMX Control
The system only accepts the DMX512 signal of international standard to control the system mode, the laser pattern
ON /OFF, the size, the position, the speed, etc.
Master-Slave Operation
This mode will allow you to link up to 32 units together without controller.
1. Install the units in a suitable position (laying or appending).
2. Choose a unit to function as Master mode, set dipswitch to select Sound Active or AUTO mode. The others must
be set to Slave mode, set dipswitch to select Slave mode.
Slave units set #3 on
3. Use standard XLR microphone cable chain your units together via the XLR connector on the rear of the units.
For longer cable runs we suggest a terminator at the last fixture.
4. Turn on the all units' power, the units begin to reset, then the units begin working. The slave units will react the
same as the master unit.
5. The units will react to the low frequencies of music via the internal microphone. Adjust the audio sensitivity knob
on the back of the master unit to make the unit more or less sensitive in sound active. The panel has LED
indicating for sound active.
DMX512
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the XLR connector on the rear of the units.
For longer cable runs we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using dipswitches; see the "DMX Address Quick Reference Char». (All
units set to #1 and #10 on will be OK)
4. Turn on all units' power, the units begins reset, then the unit begins working.
5. Use DMX console to control your units.
DMX address calculation
For DMX mode, DMX512 address from #1 to 9# dipswitches must be set, the address is set from 1 to 511. Each
dipswitch represents a binary value.
No.
Digital No.
No.
Digital No.
1st
1
6th
32
2nd
2
7th
64
3rd
4
8th
128
4th
8
9th
256
5th
16
10th
Set to 0
