ibidi Heating System, Universal Fit
Mode
Each channel of the Temperature Controller can be set to an ”On” or ”Off” state. For standard
operation all channels must be turned on.
<Mode>
Setup
Channel = 1
Mode = On
Return
Figure 14 – Mode dialog
1. Press the round button once more to move the cursor to the channel number.
2. Select the respective channel and confirm with the round button.
3. Select ”On” or ”Off” and confirm with the round button.
4. To move on navigate to ”Return” and press the round button.
Alarms
In this dialog it is possible to set the alarm limits for divergent control parameters. Move
from the mode menu to the alarm menu by pressing the ”right” button.
The maximum and minimum limits of the alarm can be set for each individual channel. If the alarm is
activated (which happens when the current value goes under/over the low/high limits), the current
value (I) blinks, showing alternately the value and ”low” or ”high”, respectively. To stop the display
blinking, navigate to the blinking channel and press the round button once.
<Alarms>
Setup
Channel = 4
High = 42°C
Low = 36°C
Figure 15 – Alarm settings dialog
Preferences
Set the brightness and contrast of the display in the preferences menu.
<Preferences>
Setup
Backlight = 65
Contrast = 15
Return
Figure 16 – Preferences dialog
Info
Info about serial number and firmware version is shown in the info dialog.
Figure 17 – Info display
Instruction Manual
25
Version 2.2 (May 23, 2019)
