iBell IBL SG60-26, Руководство оператора

Страница: 12 / 16

11

The room or object you are spraying must be properly masked or
covered in order to prevent overspray from covering woodwork,
floors or other furnishings.

It is important to keep your arm moving whenever the gun is
being triggered. If you pause in one spot too long, too much
material will be sprayed to the surface.

Partially pressing the trigger will start the turbine, but no
material will spray until the trigger is pulled fully. It is
recommended that the trigger first be pulled partially in order to
start the turbine before a spray pass is made.

Always apply a thin coat of material on the first pass and allow to
dry before applying a second, slightly heavier coat.

When spraying larger surfaces, overlap each spray pass by at
least 50% which will ensure full coverage.

Position the spray gun should be perpendicular to and 10-30 cm
from the spray surface, depending upon the spray pattern size
desired. With reduced material flow and air power, you can get
closer to the spraying surface.
GENERAL OPERATION
WARNING!
Refer page no. 6 for the specific instructions
before operating the appliance.

The spray area must be clean and free of dust in order to avoid
blowing dust onto your freshly sprayed surface.

If spraying with such a spray system is new or unfamiliar, it is
advisable to practice on a piece of scrap wood or cardboard
before beginning on intended work piece and/or test with water.
10-30 cm
IBL SG60-26