iBeam TE-HUD, Руководство пользователя

Страница: 8 / 12

7
Working temperature ：
Relative humidity
：
Alarm beep
：
Working Voltage
：
Measurement
：
Weight
：
-40c—+80c (atmospheric pressure 86 – 106 KPa)
10%-95% Noise
<=60dB (A) >=30dB (A)
9V~16Vdc (12Vdc/400mA)
9*5.4*1.2(cm)
40g
Trouble shooting
Problem Possible reason The way to solve
No speed alarm the function is closed
open the switch of alarm
No RPM speed
The setting value is too
high or the function is
closed Resetting and opening the
switch of alarm
No display after
starting The switch is not opened,
voltage is too low, the
vehicle is not OBD2
protocol Opening the switch and check
the plug, set the voltage value,
change another vehicle with
OBD2 protocol
No speed and
engine speed
display Not conform to OBDII or EU-
OBD port Consult vehicles
owner’s
manual
Speed is inaccurate
The unit of speed is
KM/H Switching the unit of speed to
MPH
1. Nothing on screen:
Make sure the TE-HUD power button is on, make sure OBD II is securely connected,
start car again.
2. Power on, but screen only show car battery voltage, and off after 30 sec:
Car might not use OBDII or EU OBD protocol, consult vehicles owner
’s manual.
3.Projection is not clear in sun light environment:
Make sure you remove the transparent film on TE-HUD screen, TE-HUD projection
position is on projection film, or you can adjust brightness as mentioned in Menu
Specification: