120-245E-R1
|
1
Note
If converting from Natural Gas to Propane, order the Propane conversion parts kit (IBC Part # P-806) from your
authorized IBC distributor.
Use the Natural Gas conversion parts kit if the fuel source at the site uses Natural Gas and the unit has been set up
(factory fire-tested) to operate with Propane. Check the rating plate on the unit to see which fuel source the particular unit
has been set up with.
Using this conversion kit, a qualified technician will need to:
1. Perform a fuel conversion.
2. Perform a combustion test.
3. Fill in the information required on the fuel conversion labels, and affix them to the unit after the conversion is
completed.
Warning
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a fire, an explosion or production of carbon monoxide may result
causing property damage, personal injury or loss of life.
The qualified service agency is responsible for the proper installation of this kit. The installation is not proper
and complete until the operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.
The unit will automatically de-rate the maximum input at a rate of approximately 2% per 1,000’ above 4,500’. The gas
valve's zero-governor will ensure that the gas-air mixture is not affected at altitude.
Included with the conversion kit:
1 x Orifice - Marked 450 - IBC Part # 180-228
1 x O-ring - IBC Part # 150-175
1 x Rating Plate Fuel Overlay - IBC Part # 080-247
1 x Gas Valve Conversion Label - IBC Part # 080-107
1 x Installer Identifier Label - IBC Part # 080-245
SFC 16-125 - Fuel Conversion to Natural
Gas (LP to NG) Kit P-807
