____________________________________________________________________________
__________________________________________________________________________________________________________
Ibath è un marchio Trem srl
Via delle Crede, 10/F - 33170 Pordenone (PN)
–
Italia
Tel. +39 0434 610 782 E-mail
C.F. e P.I. 01280430933
From the "Comfort" mode, by pressing the “Mode” button, the “Night” mode will be activated.
Similarly, by pressing the “Mode” button again, the remote control's modes will switch to: Comfort Mode –
Night Mode
–
Antifreeze Mode
–
Clock Mode
–
Pilot-Wire Mode
–
Comfort Mode***
You can chose between the following modes:
Comfort and Night Mode – setting of the mode's
temperature
(vedi Fig.1)
1.
Go to “Night” or “Comfort” mode
-
use “Plus”
or “Minus” buttons for temperature setting: by
pressing the “Plus” button once, the
temperature will rise by 0.5 degrees, by
pressing the “Minus” button once, the
temperature will drop by 0.5 degrees.
Temperature can be adjusted from 7 up to 32
degrees.
2.
The “Night” mode temperature setting can
not be
higher than the “Comfort” mode's one.
Example : If the “Comfort” mode's temperature has
been set to 25 degrees, when switching to “Night”
mode and wanting to set the temperature, once it
reaches 25 degrees, the temperature will not rise,
even when pressing the “Plus” button.
Antifreeze Mode (vedi Fig.1)
Go to “Antifreeze” mode, the temperature is fixed to
7 degrees, by pressing the “Plus” or “Minus” buttons,
the temperature cannot be neither risen nor reduced.
Clock Mode
(vedi Fig.1)
Go to “Clock” mode, the LCD display will be showing
temperature, date, time and state of the daily
program.
Pilot-Wire Mode (vedi Fig.1)
Go to “Pilot-Wire” mode – the device will recognise
the commands received from the Pilot-Wire (Comfort
/ Nigh / Antifreeze / ECO / Stand-by)
2-Hours Mode
In any mode, by pressing the “two hours” button, the
device will start to heat up the environment at full
power for 2 hours.
By pressing the button again, the remote
control will
go back to the previous mode.
(Fig 2)
Stand-by Mode
In any mode, by pressing the "Stand-by" button, the
remote control will go into stand-by mode and the
device will stop operating.
By pressing this button again, the remote control will
go back to the previous mode.
(
Fig 3)
Eco Mode
Press “Eco” botton to make appear the function’s
icon.
Press again the Eco botton to make desappera the
icon and disable the function.
Window open Mode
Press “Eco” and “-” bottons to make appear the
function’s icon.
Press again the “Eco” and “-” bottons to make
desappera the icon and disable the function.
Radar Mode
Press “Eco” and “+” bottons for 3 seconds to make
appear the function’s icon.
Press again the “Eco” and “+” bottons for 3 seconds
to make desappera the icon and disable the function.
