![background image](http://html1.mh-extra.com/html/ibase-technology/rp-103-smc/rp-103-smc_user-manual_604824092.webp)
84
RP-103-SMC User Manual
5.
SD Card Test
When SMARC is booted from eMMC, SD card is “/dev/mmcblk1” and able to see by
“ls /dev/mmcblk1*” command:
/dev/mmcblk1 /dev/mmcblk1p2 /dev/mmcblk1p4
/dev/mmcblk1p5 /dev/mmcblk1p6
When SMARC is booted from SD card, replace test pattern “/dev/mmcblk1” to
“/dev/mmcblk0”.
Note:
This operation may damage the data stored the SD card. Before starting the
test, make sure there is no critical data in the eMMC flash being used.
•
Read, write, and check
SD_DIR="/run/media/mmcblk1"
#create data file
dd if=/dev/urandom of=/var/data1 bs=1024k count=100
#write data to SD card
dd if=/var/data1 of=$ SD_DIR/data2 bs=1024k count=100
#read data2, and compare with data1
cmp $SD_DIR/data2 /var/data1
•
SD card speed test
SD_DIR="/run/media/mmcblk1"
# SD write speed
dd if=/dev/zero of=$SD_DIR/test bs=1M count=1000
oflag=nocache
# SD read speed
dd if=$SD_DIR/test of=/dev/null bs=1M oflag=nocache
Содержание RP-103-SMC
