Hardware Configuration
IOPS-302 User Manual
7
2
2.1 Installations
Before installing any card or module into the device, remove the screws
shown in the picture below to pull out the cover.
2.1.1
Memory Module Installation
To install or replace the memory modules, locate the memory slot on the
board and perform the following steps:
1. Align the key of the memory module with that on the memory slot and
insert the module slantwise.
2. Gently push the module in an upright position until the clips of the slot
close to hold the module in place when the module touches the bottom of
the slot.
To remove a module, use your fingers to press the clips outwards until the
module pops up. Grab the module gently and pull it out of the slot.
