Ibanez APEX2, Инструкция по эксплуатации

Страница: 54 / 217

52
ADJUSTING THE INTONATION
1
Use an Allen wrench (3 mm) to loosen the pressure pad bolts of the locking
nut, and loosen the strings suffi ciently.
2
Use an Allen wrench (2 mm) to loosen the saddle lock bolts, and adjust the
saddle position.
Before checking the intonation, fi rmly tighten the saddle lock bolts and tune the guitar correctly. When you
ʼ
ve
※
fi nished making adjustments, tighten the saddle lock bolts and the pressure pad bolts of the locking nut.
REPLACING THE STRINGS
1
Use an Allen wrench (3 mm) to loosen the pressure pad bolts of the locking
nut, and remove the string from the tuning peg.
2
Use an Allen wrench (3 mm) to loosen the string stopper bolt of the tremolo
unit; then pull the string out of the saddle and remove it.
3
Use wire cutters to cut off the ball end of the new string.
4
Insert the tip of the string from which you cut off the ball end between the
saddle and the string holder block, and tighten the string stopper bolt to
fasten the string.
5
Wind the string onto the tuning peg, and tune it.
6
When you ʼ ve fi nished tuning, tighten the pressure pad bolts of the locking nut.
Removing all strings at the same time will cause the tremolo attachment angle to change signifi cantly, so we rec-
※
ommend that you replace the strings one at a time. If you remove all strings at the same time, tuning will be easier
if you wedge a piece of cloth below the tremolo to secure it so that the tremolo attachment angle won
ʼ t change
signifi cantly.
Memo
Before you tune, make sure that the string stopper bolts are fi rmly tightened. •
FINE TUNING
Even after you've used the locking nuts to lock the strings, you can use
the fi ne tuners to fi ne-tune each string.
The range of adjustment after the strings are locked will be widest if you
leave all fi ne-tuning bolts near the center of their adjustable range before
you tune.
NA12G133.indb 52 NA12G133.indb 52 2012-10-24 11:16:04 2012-10-24 11:16:04