ibaMS8xAI-110VAC
Manual
Issue 1.4.1
11
Important note
Always screw tight the device and the modules. If you do not screw it tight, connecting or
disconnecting the connectors for the inputs and outputs might cause damages.
6.2
Connecting
Note
The backplane unit and the device must be connected to a protective conductor.
1.
Connect all cables.
2.
If all required cables are connected, connect the central unit to the power supply.
3.
Switch on the central unit.
6.3
Dismounting
1.
Disconnect the central unit from the power supply.
2.
Remove all cables.
3.
Remove the both fixing screws on the upper and the lower side of the device.
4.
Pull the device straight from the backplane.
5.
Put the cover on the backplane bus.
Note
The device is safely disconnected from the power supply only when the central unit is
disconnected. The connector X1 serves for disconnecting the measuring circuits.
