Modello - Modèle - Model
Modell - Modelo - Model
ARMADIO PROFESSIONALE - SERVICE CABINET - ARMOIRE PROFESSIONNELLE
BERUFS KÜHLSCHRANK - ARMARIO PROFESIONAL - PROFESSIONELE KOELKAST
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante - Fabrikant
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
16/64
N° DOC
UM000348
13. OUTER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER PLUG
BEFORE CLEANING.
For a good preservation of the cabinet’s body a periodical cleaning is necessary.
1.
EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and water solution.
2.
STAINLESS STEEL SURFACES:
Wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid
scouring pads etc. which will spoil the finish of the stainless steel.
3.
SURFACES IN PLASTIC MATERIAL:
Wash with warm water and mild detergent, rinse well and dry with soft cloth; under
no circumstances should alcohol, methylated spirits or solvents be used.
14. TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER PLUG
BEFORE CLEANING.
To always get the best performance out of the refrigeration system, a manual defrost is recommended when the thickness of
the frost in the tank is greater than 5 mm (AB N); proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves.
2. Before cleaning the tank the inside temperature must be equal to the ambient temperatur.
3. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as the ambient
temperature.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
5. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
6. Clean the height adjusters supporting the levels with a jet of air.
7.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
WARNING!
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
WARNING!
Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
15. CONDENSER CLEANING
Remove periodically from the condenser unit ventilated or static the impurity (dust and deposit) which
remain among the fins of the condenser, obstructing a good circulation of the air.
A dirty condenser reduces the performance of the equipment, increasing the energy consumption.
Cleaning should be carried out with a soft brush or preferably with a vacuum cleaner.
16. PROLONGED SWITCH OFF
When the unit is kept unused for a long time, please take note of the following procedures:
• unplug the unit;
• clean and dry well the tank;
• leave the door open to avoid possible formation of bad smells;
• cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
