5
WSC Worksurface Support Beam Assembly:
1055111 (1-cab) 1055112 (2-cab)
Item
Description
Qty
1
Support Beam Front
1
2
Support Beam Rear
1
HARDWARE KIT #HWR148 (1 Cabinet 96”)
A
Beam Connector Plate
2
B
Hex Head Bolt 5/16-18
4
C
1/4 Flat Washer
8
D
Screw, #14 X 1.00 PPH SMS Black 4
HARDWARE KIT #HWR159 (2 Cabinet 96”)
C
1/4 Flat Washer
8
D
Screw, #14 X 1.00 PPH SMS Black 8
Step 1:
(HWR148 only)
Attach beam connector plates item A to one end of the each of the two support beams using the
5/16-18 x .75 hex head bolts item B and 1/4 flat washers item C from the above supplied
hardware as shown. DO NOT TIGHTEN THE HARDWARE. With the worksurface face down on a
protective surface, place the two support beams on the worksurface with the open sides facing in.
Step 2:
(HWR148 only)
Align the workbench pedestal over the ends of the support beams and lower them down over the
beam connector plates so that the plates are on the inside of the pedestal tubing. Align the slots
in the pedestal over the pilot holes on the worksurface and install it using #14AB X 1.00 screws
items B and 1/4 flat washers items C from Hardware Kit HWR 144 leaving them loose. Tighten
the beam connector hardware to the pedestal only at this time.
