11
WSC Lower Metal Shelf Cabinet to Cabinet Assembly:
Item
Description
Qty
1
Lower Metal Shelf 2 Cabinets
1
HARDWARE KIT HWR147
A
Bracket, Cab Footrest LMS
2
B
Screw, #14AB X .625 PPH SMS Black 4
C
1/4 Flat Washer
16
D
Nut, 1/4-20 Hex Keps Black
4
E
Stud Weld 1/4-20 X .75 Right Angle 4
Step 1:
Install the weld studs item E, 1/4 flat washers item C, and 1/4-20 hex keps nuts item D into the
cabinet footrest LMS brackets as shown below on the right. Do not tighten the hardware. Attach
the bracket assemblies to the side of each cabinet using the phillips screws item B and 1/4 flat
washers item C. Be sure the weld studs are positioned so that they will be in the lower slot of
each of the brackets when the bench is turned over on
to it’s cabinets. Tighten the phillips screws
to the cabinet side.
Step 2:
Fit the lower metal shelf between the two cabinets so that the slots at each end can be aligned
with the hardware installed in the cabinet footrest LMS brackets. Lift the lower metal shelf into
place and adjust the hardware into the slots and hand tighten so that the shelf will hang on the
hardware. Adjust the lower metal shelf forward or back to the desired location. Tighten all
hardware at this time.
Step 3
At this point the bench assembly is very heavy. Be sure that no assemblers are injured in the
process of turning the bench over onto its cabinet base assemblies. Turn the bench over onto its
cabinet base assemblies being very careful not to damage the worksurface by either drop it or by
pulling on the cabinet bases too hard. When the bench is turned over install the drawers into the
cabinets and continue the assembly if other items are needed.
