Wi PLUS
USER MANUAL | 23
Ceiling Mode only
When projector OSD message is shown, this may result failure to Auto Calibration
and Auto Touch Area Setting. Please wait until OSD message is gone before
performing Auto Calibration and Auto Touch Area Setting.
Please follow below trouble-shooting steps to perform Auto Calibration and Auto
Touch Area Setting again.
a.
Quit all software application
b.
Reduce ambient light
c.
Do not obstruct or shake lens during Calibration
d.
Check if projection image is clear. If not, adjust focus to sharpen the image.
e.
If the “Auto Touch Area Setting failed” or "Auto Calibration failed" message
pops up on screen again, please switch to Manual Mode to do Touch Area
Setting and Calibration.
2.
Please check Projector Lamp Power Mode selection. Lower lamp brightness
(ECO mode) may affect both Auto Touch Area Setting and Auto Calibration.
Please switch to Normal mode to complete Touch Area Setting and Calibration.
3.
Please check Projector Color Mode selection. To ensure accuracy of both Auto
Touch Area Setting and Auto Calibration, it is suggested to switch Color mode
to Bright Mode.
Содержание 3303WI
Страница 1: ......
Страница 25: ...Wi PLUS USER MANUAL 25 2 Select Smaller 100 Default and click Apply ...
Страница 28: ...28 Learn more about i3 products at www i3 learning com ...
