12
i3-TRNG-CAMS-Ax47R_67R-UM.indd
Rev. 171109
1/2” thread
7. Secure the camera module to the
Ax61BB back box with three screws
(not provided with the camera).
8. Pull the camera cable through the
opening in the Ax61BB housing. Feed
the CAT5/6 cable through the supplied
waterproof RJ45 connector assembly
before crimping and plugging in.
9. Connect all wiring.
10. Adjust the lens angle by rotating and
panning the camera lens base. Do not
over-rotate the camera lens beyond
the stop point to avoid damage to the
camera.
See Section 4.1 for more info.
Tip:
For the ease of setup, lift off the
camera liner while adjusting the lens position. Once the desired view has been
achieved, replace the camera liner until it snaps into place.
11. Replace the camera dome housing on top of the camera module.
12. Use the supplied Torx bit to re-tighten 3 silver screws securing the dome bubble
housing to the camera module.
Retaining
clip
4.6 Camera Wiring Options
Based on installation requirements, you may route the cable through the cut-out open-
ing on the side of the camera’s mounting base (Option A) or through the pre-drilled
opening in the surface (Option B). For Option B, drill a 13mm (0.5”) circular opening in
the mounting surface, corresponding to the “Cable hole” of the drill template.
Option A
Option B
