2.4.2 Channels Setup
In the
Channels
Setup, authorized users can perform the following tasks for each selected video
channel:
• Assign/change channel name.
• Display/hide channel name, change the position of the channel name on the video screen.
• Display/hide timestamp and day of the week; change the position of the timestamp on the video
screen; change the display style of the timestamp if enabled.
• Display/hide up to 4 personalized text messages on the video screen – called
text overlay
.
• Enable video privacy masking, set up to 4 video privacy masking areas.
• Change the display and recording resolution for the main and sub video streams.
• Change the display frame rate for the main and sub video streams.
• Change other transmission settings: I Interval, BitRate Type, BitRate, and Frame Type.
2.4.3 Network Setup
The RJ-45 Network Port on the IP camera allows it to be connected to an Ethernet/Fast Ethernet
standard (10/100Base-TX) network, complying with the IEEE 802.3U standard. Annexxus device
may be connected to a hub, switch or router with a straight through CAT5e cable, or directly to
the DVR/NVR with a crossover CAT5e cable.
See Annexxus Default IP Configurations section for information on Annexxus factory default IP
configurations.
In the
Network
Setup, authorized users can obtain the network camera's MAC Address; change
its IP Address, Subnet Mask, Gateway IP, Multicast IP, Host Port (for Video/Audio) and/or HTTP
Port (for Web access). Please contact your network administrator for more information on your
network particulars.
Important:
Make sure to open all ports required for remote viewing. The following ports must be
forwarded: 80, 554, 8000, 8200.
10
