I-Tech 17908, Руководство пользователя

Страница: 36 / 56

IACER Srl 36 MNPG118-02
10. Place the electrodes on the area to be treated
following the instructions of electrodes position
manual. In case of treatment with 4 poles
interferential waveform place the electrodes as
shown in the picture on the right.
11. Select the two channels intensity by using the
knobs (1-2) placed on the left upper side of the
front panel.
ATTENTION
. The device has a current supply safety system and the
identification of the connected load: in case of disconnected
electrodes/cables or damaged electrodes if the intensity is set above
10mA/10V the device emits an acoustic signal and the intensity
value on the display starts flashing.
It’s possible to stop temporary the therapy at any time pressing the knob
(3). Press again the knob to continue the treatment.
12. Press the orange button to stop immediately the treatment in
progress.
ATTENTION . For safety patient, the device is equipped with a
protection system against high temperatures. The device will stop
electrical stimulation when the feature board temperature
reaches 80° C. The device cannot work again unless the
temperature is below 60°C.
Programs features and therapeutic indications
Interferential waveform with 4 poles – IF-4P
Prg Phase CC/
CV
Vector
(Auto)
Vector
(Manual)
Carrier
Freq.
(C.F.)
High
Freq.
(Beat.
H)
Low
Freq.
(Beat.
L)
Time
1
1 CC 0 45° 4.0kHz 110Hz 100Hz 15min
2 CC 0 45° 4.0kHz 110Hz 100Hz 0min
3 CC 0 45° 4.0kHz 110Hz 100Hz 0min
2
1 CC 0 45° 4.0kHz 150Hz 100Hz 10min
2 CC 0 45° 4.0kHz 150Hz 100Hz 0min
3 CC 0 45° 4.0kHz 150Hz 100Hz 0min
3 1 CC 0 45° 4.0kHz 50Hz 50Hz 15min