i-onyx VN-855V5, Руководство по установке и эксплуатации

Страница: 35 / 38

31
Technical Information
24 VAC, ±15% or PoE (802.3af
compatible).
Standard network protocol type
using IP addressing scheme and
separate PC application
software.
Network Setup:
Internal fully isolated power
input.
Camera can be setup using
remote recorder or workstation
GUI. Permissions can be
assigned for macro create &
edit, alarm setup, Authentication,
Reports and System Status.
Supports up to 20 Groups and
100 Users.
Site Authorization:
VN-855: 360 mA max.
VN-855DN: 410 mA max.
VN-855WDR: 380 mA max.
250 mA @48 VDC (PoE)
VN-855: 5.8 W max.
VN-855DN: 6.5 W max.
VN-855WDR: 6.4 W max.
System macros can be
configured to use the camera’s
video. In addition, within macros,
alarms can be sent and remote
macros run.
Macro Create & Edit:
0.3 btu/min (0.09 kg-cal/min)
nominal.
Note: These figures represent
the conversion of 100% of the
electrical energy to heat. Actual
percentage of heat generated
will be less and will vary from
product to product. These
figures are provided as an aid in
determining the extent of cooling
required for an installation.
An alarm can be triggered on
video motion detection and loss.
The alarm can be sent to remote
units.
Alarm Setup:
The video from the camera can
be set to view the Authentication
status symbol (A) on the
displayed video. Authentication:
Refer to Table 1 (based on
24 VAC, standard camera).
Picture Quality and FPS
Priority:
Camera video can be setup to
prioritize recorded picture quality
and video FPS. Priority can be
assigned to user/macro
recording for highest requested
video quality or Master user
control.
FCC Class A/CE.
ViconNet Digital Video
Management System Version 5.
1/3-inch interline transfer CCD. Image Device:
10/100 Mbps, TCP/IP Unicast.
Active
NTSC: 768 (H) x 494 (V).
Picture Elements:
1, over LAN connection.
PAL: 752 (H) x 582 (V).
VN-855/VN-855WDR
Sensitivity:
NTSC and PAL, model
0.09 fc (1.0 lux) at standard gain;
dependant.
0.07 fc (0.7 lux) at high gain.
VN-855DN
30 fps (25 fps, PAL).
0.0009 fc (0.01 lux) in night
mode; 0.07 fc (0.7 lux) in day
mode.
Conditions: lens at f/1.2 and
40 IRE video output.
Maximum 10 viewing/recording
streams per camera.
Horizontal
VN-855/ N-855DN: 540 lines
Resolution:
ViconNet software quality 1-8,
selectable on a 4-position bar
VN-855WDR: 480 lines.
with 2 compression level settings
in resolutions 720 x 488 (863 x
586 PAL), 720 x 244 (863 x 293,
PAL), 360 x 244 (432 x 293,
PAL), 360 x 122 (432 x 146,
PAL).
NTSC: 1/60-1/100,000.
Electronic Iris:
PAL: 1/50-1/100,000.
NTSC standard: 2:1 interlace,
525 lines, 30 frames/sec.
Scanning System:
PAL standard: 2:1 interlace,
625 lines, 25 frames/sec.
1 line-level microphone input;
0 dbm, 32 KHz bandwidth, 600
ohm impedance, 2 V RMS (1 V
p-p) output.
Backlight
Compensation/Wide
Dynamic Range: ON/OFF select.
1, select N.O./N.C.
XX181-05-00 Rev 1208 VN-855V5 IP Camera
1.7 Mbps (per video stream),
nom.
Refer to Table 2.
Input Power Source:
Input
Power Isolation:
Current:
Power
Consumption:
Heat Equivalent:
Maximum Power Cable
Distance:
Radio-Frequency
Emission Standard:
Communication
System:
LAN Interface:
Number of Video
Channels:
Video Formats
Supported:
Video Transmission
Rate:
Number of
Simultaneous Video
Streams:
Video Quality:
Audio:
Alarm:
Video Bandwidth:
Hard Drive
Consumption Rate:
ELECTRICAL
VICONNET (IP)
SOFTWARE OPERATION
VIDEO CHARACTERISTICS
Table 2
Hard Drive
Consumption
60 200 300 500 600 900 1000 2000 3000
Days Recording
24 80 120 200 240 360 400 800 1200
Remote Hard Drive Storage (GB)
VN-855V5
Note: This table is based on the following conditions:
- 24 hours normal activity with 50% detected movement over time, Normal compression and Quality Q5 (320 x 240 pixels NTSC, 384 x 288 pixels PAL)
- Recording durations may vary based on actual scene activity.