i-mobile IMT-10 PLUS, Руководство пользователя

Страница: 5 / 37

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may case harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which to receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cord is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not make any
changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should
be made, you could be required to stop operation of the equipment.
FCC Caution:
1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions
1 This device may not cause harmful interference.
2 This device must accept any interference received, including interference that may cause undesired operation.
2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
3. FCC RF Radiation Exposure Statement
This device has been tested for compliance with FCC RF Exposure (SAR) limits. The equipment complies with FCC RF
radiation exposure limits set forth for an uncontrolled environment.
4. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user
authority to operate the equipment.
CE Statement
This equipment has been designed to comply with EMC directive 89/336/EEC
And Decision 768/2008/EC
As an amended by 92/31/EEC and the Low Voltage directive 2006/95/EC,
This equipment has been comply with EMC directive 2011/65/EU
And Decision 768/2008/EC
Manufacturers will need to test and approve the product to these directives.
Click here to buy
A
B
B
Y
Y
PD
F Transfo
rm
er
3
.0
w
w
w .A
B B Y Y.
c o
m
Click here to buy
A
B
B
Y
Y
PD
F Transfo
rm
er
3
.0
w
w
w .A
B B Y Y.
c o
m