8
SAFETY TIPS
WARNING:
The warnings and
instructions listed and described
hereafter must be followed at all
times. If there is any uncertainty
regarding an intended use of the
HFJ-400,
contact
your
supervisor. Failure to observe these warnings and instructions may
result in injury and/or property damage.
1. Both the
HFJ-400
jack and the fork lift must be on a firm lever surface
capable of supporting the load. Do not attempt to lift from a polished
or greasy floor.
2. The
HFJ-400
may be used to lift from either side or end of the fork lift
truck. However, 2 wheels of the lift truck must remain firmly on the
floor.
3. Use extreme caution when lifting narrow fork lift trucks (less than
1016mm Wide) from the sides. Always make sure that the height
between the floor and the bottom of the raised tyre is never more than
one fourth (1/4
th
) of the vehicle’s tread width. See Fig.6.(Tread width
is measured from centreline to centreline of the tyre treads.) If the one
forth figure is exceeded, the fork lift truck could reach the point of
instability and tip over or the angularity of the forklift truck frame could
cause the jack to kick out and drop the load.
Example: If treadwith=914.40mm,then never lift the bottom of the
vehicle tyre more than 228.60mm off the floor.
WARNING
ht
TREAD WIDTH
Fig.6
www.dominga.lt/krautuvai mob. tel.: +370 686 61770 tel.: +370 5 2432146 el. paštas: [email protected]
