Appendix 2 - FCC Information
A2-1
IBC2602 User's Guide
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received
including interference that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the
limits for a Class A" digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may
cause interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at their own expense.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE
: This product was FCC verified under test conditions that included the
use of shielded I/O cables and connectors between system components. To
be in compliance with FCC regulations, the user must use shielded cables
and connectors and install them properly.
Содержание IBC2602
