I.A.V. Piccolo, Руководство пользователя

Страница: 12 / 13

NOT START WHEN THE
TURNTABLE IS
SWITCHED ON disconnected from the AC wall plug AC wall plug works
The Turntable just does
not start
•
Have you wrapped the Belt
around the Pulley and the Platter
properly
•
If not just do it
•
The electrical connection inside
the turntable could be damaged
•
Contact your dealer for
assistance
When the turntable is
switched on it does not
start automatically and the
motor makes a vibration
•
The Belt is too slack and does
not produce the necessary friction with
the pulley
•
•
The 3 stainless steel screws of
the gold plated motor cover are too
tighten
•
Unscrew them enough to let
the motor spins without making noise,
they need just to be very gently screwed
to the motor cover
When the turntable is
switched on it does not
start automatically
•
The Platter Bearing/Spindle
system are very dirty making a too strong
friction
•
TROUBLESHOOTING 9
Piccolo
Italian Prestige Rigid Turntable
F.A.Q.
Adjustment
PICCOLO Turntable
ACTION
DESCRIPTION HOW TO DO ADJUST IT
DUST COVER FRICTION
ADJUSTMENT
•
The Dust Cover is hard or
slack during open/close adjustment
•
Adjust the single screw present on each hinge till
you reach your proper wanted friction
LEVELLING THE TURNTABLE
•
The Turntable is not levelled
•
With a spirit level, only level the Turntable
Platter through its shelf layer eventually screwing its feet
just for very fine adjustment, take care of levelling the
platter on its vertical and horizontal lines
•
The Turntable is not levelled
•
Be sure that the turntable layer is enough solid
and rigid to support the weight of the turntable easily
SPEED ADJUSTMENT ON THE
ADJUSTABLE ALUMINIUM PULLEY
•
The aluminium adjustable
pulley doesn’t spins at the right speed
•
With the help of a “coin” screw clockwise or
anti-clockwise the pulley’s internal cone to increase
(clockwise) or decrease (anti-clockwise) the speed.
Check the right speed with a proper stroboscope
VTA ADJUSTMENT
•
VTA tone arm is not
adjustable
•
The 3 arm board collar hex bolts are screwed into
the collar too much and do not let the arm shaft gets in it;
unscrew the hex bolts before inserting the arm