Hyundai VC 004 B, Инструкция по эксплуатации

Страница: 36 / 56

EN - 36
After vacuum cleaning
Switch off the device when you have finished cleaning:
1) To do this press the foot button P9 on the device with your foot or by hand.
2) After this pull the mains plug from the socket.
3) To roll in the cable press foot pedal and hold it in position. The cable will be rolled back
automatically onto the installed cable drum and disappear completely into the device
up to the plug.
4) The floor nozzle can be kept attached to the vacuum cleaner for ease of storage after
use.
Motor thermostat
This motor is equipped with a motor protective thermostat. If for some reason the vacuum
cleaner should overheat, the thermostat will automatically turn the unit off. Should this
occur unplug the vacuum cleaner from the wall outlet and turn off switch. Change the dust
bag or filter. Allow the unit to cool for approximately 45 minutes. To restart, replug into wall
outlet and turn switch back on.
V. CLEANING AND MAINTENANCE
Always remove the power plug from the wall outlet before carrying out any maintenance.
If the suction power of your machine is getting lower, you must change the dust bag and
clean the filter. To do so, please follow the instruction below.
1) Open the front cover fig 1.
2) Remove the dust filter bag holder fig. 2.
3) Change new bust filter bag.
Fig.1 Fig.2
Motor protection filter
The motor protection filter cleans the air that is sucked in before it enters the motor. The
air is cleaned of fine dusts, mites, bacteria and viruses. This prevents dirt or dust particles
from getting into the motor or the surrounding air.
1) Take out the dust filter bag
2) Take out enter air filter piece fig. 3.