Hyundai MSD 761 DRSU, Инструкция по эксплуатации

Страница: 83 / 112

ENG
ENG - 83
TROUBLESHOOTING
Before resorting to maintenance service, please kindly check by yourself with the following
chart.
Symptom Cause(s) Remedy
No Power
The AC power cord is not connected
to the power supply or is not connected
to a power supply securely.
Please check that the AC power cord
is connected securely.
Picture
There is no picture or the picture is
distorted.
The video cable isn‘t connected securely.
Video output mode of the unit isn‘t correctly
set.
Video input mode of the connected TV isn‘t
correctly set.
Connect the video cable securely.
Press [V-MODE] repeatedly until the picture
becomes normal again.
Set an appropriate video input mode.
Sound
There is no sound or the sound is dis -
torted.
The audio cables aren‘t connected securely.
The volume is set to the minimum level.
The sound is switched off.
The disc is in fast forward/reverse playback.
Connect the audio cables securely.
Turn up the volume.
Press [MUTE] on the remote control to switch
on the sound.
Press [PLAY/PAUSE].
Unable to play a disc
This disc is placed in the disc tray in a wrong
way.
The rating of the disc is higher than the rate
set in the parental control item.
The unit isn‘t compatible with the disc.
The disc is dirty.
Check that the disc is placed in the disc tray
with its label side upwards.
Reset the settings in the parental control item.
Clean the disc.
The player breaks down when a USB
drive or memory card is inserted
into the player.
The connected USB drive or the memory
card is probably not a certified one.
The player cannot play any uncertified USB drive
and memory card.
In case the player breaks down, turn it off,
disconnect the power cord from the AC outlet
and unplug the USB drive or/and the memory
card from the player. Then, power on the player
again. The player will resume the normal status.
The buttons on the unit doesn‘t work.
The unit is being interfered with static
electricity etc.
Switch off and unplug the unit.Then connect
the plug to the power supply and switch it on
again.
The remote control does not function.
There is no battery in the remote control.
The batteries are out of charge.
The remote control isn‘t pointed to the remote
sensor.
The remote control is out of its operating
area.
The unit is shut down.
Install two AAA/1.5V batteries in it.
Replace the batteries with new ones.
Make sure that the remote control is pointed
to the remote control sensor.
Make sure the remote control is within
the operating area.
Switch off the unit and disconnect it from the AC
outlet. Then power on the unit again.