Genuine Accessories
Ratchet, Extension, 10mm Socket, Pliers
12
13
Caution : Do not pinch the factory harness & Remote Start T-Harness
between the fuse box and steel tubing.
N
O
T
E
A. Locate the two (2) connectors on the driver's kick panel area as shown
above.
B. Identify and disconnect the UPPER factory 68-pin Female Light & Horn
Connector.
N
O
T
E
A. Plug the corresponding Remote Start T-Harness connectors into the factory
module and the factory 68-pin connector.
B. Using one (1) Wire Tie, secure the T-Harness to Factory Harness as shown.
N
O
T
E
A. Using a Ratchet, Extension and 10mm Socket, remove the two (2) 10mm nuts from the fuse box.
B. Store the two (2) 10mm Nuts in a safe location for reinstallation.
C. Slightly pull the fuse box forward to access the rear.
D. Locate the 20-Pin female connector (Green), found on the fuse box right side as shown above
.
E. Using Pliers, crimp the small end of the T-Tap onto the Red Wire of Remote Start Harness and repeat procedure for Blue Wire of Remote Start Harness
F. Match the T-Taped Red Wire of Remote Start Harness to
Red Wire (Pin #19)
of Vehicle 20-Pin CAN Connector and using pliers, crimp the large end of the T-Tap onto
Red Wire (Pin #19)
of Vehicle 20-Pin CAN Connector. - Refer to the T-Tap Installation Procedure on page 3.
G. Match the T-Taped Blue Wire of Remote Start Harness to
Blue Wire (Pin #9)
of Vehicle 32-Pin CAN Connector and using pliers, crimp the large end of the T-Tap onto
Blue Wire (Pin #9)
of Vehicle 20-Pin CAN Connector. - Refer to the T-Tap Installation Procedure on page 3.
Make sure to check the Correct wire Pin location for both T-Tap installations.
Connect T-Tap into Any wire if there are two wires in 1(one) Pin.
11
Wire Cutters
10mm Nuts
68-Pin Female
Light & Horn Connector
20-pin CAN
Connector
(Green)
Remote Start
Blue Wire
T-Tap
Vehicle Blue Wire
Pin #9 (CAN-L)
Vehicle Red Wire
Pin #19 (CAN-H)
Remote Start
Red Wire
Wire Tie
Factory
Harness
WIRE SIDE VIEW
Revision Date
06/05/2020
Page 8 of 13
