Genuine Accessories
A. Remove the fuse panel cover.
B. Gently pull the weatherstrip back from the dash area.
C. Using a trim removal tool, remove the driver’s side dash end cap panel
by prying outward to disengage the four (4)
Pressure Clips.
D. Store the removed parts in a safe location for reinstallation.
N
O
T
E
Caution: Do not damage the Dash Panel, Fuse Panel Cover or Dash End
Cap. Make sure no pressure clips remain in the dash board.
WARNING! Shock Hazard. Do not touch vehicle's negative
battery terminal to vehicle's positive battery terminal. Serious
physical injury or electronic component damage may occur.
1
N
O
T
E
4
A. Open the Driver's Door Window.
B. Move the Driver's Seat to the rearmost position.
C. Record all pre-set radio stations, if applicable.
D. Pull the Hood Lever to open the Hood.
Ratchet and 10mm Socket
N
O
T
E
N
O
T
E
3
A. Using a Ratchet, Extension and 12mm Socket, remove the one (1) 12mm
Bolt from the bottom of panel as shown.
B. Using a Phillips Screwdriver, remove the two (2) phillips screws
from the left side of panel as shown.
C. Store the removed screws and bolt in a safe location for reinstallation.
A. Remove the vehicle's Negative (-) Battery Cover and place it in a safe
location for reinstallation, if applicable.
B. Disconnect and isolate the vehicle's Negative (-) Battery Cable.
Ratchet and 12mm Socket, Extension and #2 Phillips
Screwdriver
Caution: Do not damage the Lower Dash Panel.
2
Trim Removal Tool
Pressure
Fuse Panel
Cover
Dash End Cap Panel
Negative Battery
Cable
12mm
Bolt
Phillips Screws
Revision Date
06/05/2020
Page 4 of 13
