Charging the battery
It is necessary to charge the accumulator at least 14 to 16 hours before first use. Plug the
adaptor
G
into the el. mains. Slide the connector of the adaptor lightly into the socket
A5
in
the cleaner (placed in holder
C
). The operation of charging of the accumulator is indicated
by the indicator
A2
(pic. 6). The accumulator is usually fully charged after approx. 10 hrs
and gives operation time for. 13 minutes. Turn the cleaner off before charging! Maximum
charging time is 10 hours, do not exceed this time!
CAUTION
– Do not charge the battery for more than 24 hours!
– If you charge the battery for the first time or after long storage, about 60 % of its total
capacity is charged. After repeated discharge and repeated recharge the battery is charged
to 100 %.
– Let the charger cool down for at least
15 minutes
between charging.
– After completing hard work or in hot environment, the battery may be too hot for charging.
Let the battery cool down before charging.
–
The control light
A2
does not provide any information about how much the battery is charged.
Using the vacuum cleaner
Disconnect the charger connector from the socket
A5
and remove the vacuum cleaner
from the holder. Choose suitable accessories (
D
,
E
,
F
) according to the type of the cleaned
surface. Slide the selected adapter end-to-end to the hole in the dust container
B
(Fig.
4). You can turn the vacuum cleaner on and off by the switch
A1
(Fig. 6). Let the vacuum
cleaner recharge as soon as its suction performance is weaker. In everyday use of the
appliance, let the vacuum cleaner connected to the charger. In this way the appliance will
always be fully loaded. Battery overcharging is not possible. If you are not present for longer
time (more than one day), remove the charger from the electric socket to save energy.
Vacuuming dry impurities
Select the suitable accessories (
D
- brush adapter for cleaning fine surfaces,
E
- slot adapter
for cleaning corners and narrow gaps). Slide the selected adapter end-to-end to the hole in
the dust container
B
. Remove the adapter in the opposite direction.
Vacuuming wet impurities
Slide the adapter (
F
- rubber scraper) end-to-end to the hole in the dust container
B
. Push
the scraper slightly to the surface that you want to clean and hold the vacuum cleaner tilted
in the angle of about 30 degrees. Make sure that the scraper is constantly in contact with the
surface during vacuum cleaning (Fig. 5).
CAUTION
– When vacuuming wet impurities, the vacuum cleaner cannot be turned with the dust
container upside down, laid down or bent to one side or shaken.
– If the level of the liquid in the container reaches the maximum gauge (it´s max 200 ml), stop
vacuuming the liquid.
– After every use of the vacuum cleaner for vacuuming liquids or wet impurities empty and
wipe thoroughly the container, the protector and the filter before you put it in the holder.
Emptying the dust container
If the amount of impurities in the container reaches the
MAX
gauge, it has to be emptied.
Release locking of the container
B
by pressing the
A3
button and remove it from the vacuum
cleaner by tilting (Fig. 7). Pull out the filter
B1
and the filter protector
B2
from the container (Fig.
8), then place the container over a dustbin and empty it into common municipal waste (Fig. 9).
Slide the protector and the filter back to the container end-to-end.
GB - 25
GB - 24
