13
assembly continued…
3.9
3.10
Fit the chain cover back to the power unit making sure the chain tensioner stud
passes through the lower adjustment hole on the guide bar
, you may have to
adjust the positiin with a flat screw driver to ensure alignment (8)
and tighten the
nuts finger tight (7).
While holding the tip of the bar
up,
adjust the chain tension by turning the
tensioner screw until
chain is to the correct tension it should be snug fitting on
the bar, with no droop in the cahin along the bottom of
the guide bar rail (8 & 9).
3.11
Tighten the chain cover nuts securely with the bar tip held up (12~15Nm).
Then check the chain for smooth rotation and proper tension by moving it by hand.
Do not over-tighten.
If necessary, re-adjust with the chain cover loose.
CAUTION
The saw chain is very sharp and
MUST
be handled using thick protective gloves.
NOTE
A new chain will stretch in length when first used. Check and re-adjust the tension
frequently as a loose chain can easily derail or cause rapid wear of the saw chain
and the guide bar.
9
Содержание HYC6200X
Страница 1: ...1 PETROL CHAINSAW HYC6200X...
Страница 28: ...28 13 DECLARATION OF CONFORMITY...
Страница 30: ...30 NOTES...
Страница 31: ...31 NOTES...