Hyundai HSPA800-AC, Оригинальное руководство пользователя

Страница: 25 / 32

25
The paint
pattern is tailing.
The spray gun Mesh Filter, the Spray
Tip (5), or the Suction Hose Filter (15)
is clogged.
Clean spray gun Mesh Filter, the
Spray Tip (5), and the Suction Hose
Filter (15).
The Suction Hose (16) is loose at the
Suction Hose Inlet Port (17).
Re-adjust the Suction Hose (16) to the
Suction Hose Inlet Port(17).
The Spray Tip (5) is worn. Replace the Spray Tip (5).
The paint is too thick. Thin the paint according to the
manufacturers instructions.
13.Maintenance & Storage
Assembling the Spray lip & Nozzle Guard to Spray Gun
NOTE: The Spray Gun (6) comes assembled from the factory. If the Spray Gun (6) has been
disassembled for cleaning, follow the steps below to re-assemble.
1. Insert the mesh filter into the Handle (7) and align the Handle (7) with the upper body of the
Spray Gun(6) (Fig.13a).
2. While holding the upper body of the Spray Gun (6), tighten the Handle (7) using the supplied
wrench (Fig,1 3b).
3. Hook the bottom edge of the Trigger Guard (2) into the hole in the Handle.
4. Ensure the small spacer and washer that locate the Spray Tip (5) are inserted in the Nozzle
Guard (4) (Fig.13c).
5. Place Trigger Guard (2) over the end of Spray Gun (step 1) and insert Spray Tip (5) into the
Trigger Guard (step 2) (Fig.13d). Make sure that the Spray Tip (5) is rotated forward to the spray
position with the arrow on the tip facing forward.
6. Tighten the retaining nut (Fig.13e),
WARNING! Do not spray without the Spray Tip (5) and Nozzle Guard (4) in place. Do not
press the Trigger (3) unless the Spray Tip (5) is correctly installed in the spray position. Always lock
the rigger (3) before removing, replacing or cleaning the Spray Tip (5).