30
3. 7 AUXILIARY HYDRAULICS
To operate an attachment such as a grapple fork the Left
Hand Control Lever will be used. Push right of neutral on
the Auxiliary Hydraulic Control Switch to open the
grapple (See Fig. 3.6J).
To close the grapple (Fig. 3.6K), push left of neutral on the
Auxiliary Hydraulic Control Switch, or push down on the
toe of the auxiliary pedal if so equipped.The lift arm and
the bucket pedals can be used to raise and tilt the grapple
as with a bucket.
To operate an attachment which requires a constant flow of
oil such as a backhoe or sweeper, a toggle switch on the
L.H. instrument panel (Fig. 3.6L) should be placed in the
ON position.
When the auxiliary circuit is not in use switch to the OFF
position otherwise starting the loader may be difficult or
impossible and damage to the starter may occur.
Return the auxiliary
control to neutral when
not in use otherwise
starting may be
impossible and damage
to the starter may occur.
IMPORTANT
3. OPERATION
Fig. 3.6J
Fig. 3.6K
To avoid personal injury, lower
the lift arms, shut off the
engine, raise the seat bar and
cycle the lift arm and bucket
controls to ensure they are
locked. Then, unlatch the seat
belt and exit the loader. Do not
enter or exit with the engine
running unless as specified in
this manual or under specific
service and backhoe operating
procedures.
WARNING
C723
C724
C3022
C3022
C3793
Fig. 3.6L
Toggle Switch
