6.
insert batteries in the remote control,
fi tting the side brushes,
set up the charging station,
charge the device’s rechargeable battery.
Inserting batteries in the remote control
Open the battery compartment cover on the back of the remote control by pressing
the catch together with your thumb and fold up the cover.
Insert the batteries in the battery compartment. Make sure that the polarity is
correct as indicated in the compartment (+/–).
Put the battery compartment cover back on the battery compartment and fold it
into the closed position. It must audibly lock into place.
When the remote control starts to lose power, the batteries must be replaced.
Fitting the side brushes
Place the device upside down on the ground or a table.
Fit the side brush marked with R on the receptacle on the device that is marked with
R.
Fit the side brush marked with L on the receptacle on the device that is marked with
L.
The side brushes must audibly lock into place.
Set up the charging station
ATTENTION!
The charging contacts on the device and on the charging station should always be
free of dust and clean so that the rechargeable battery can be charged.
Place the charging station on a clean, level fl oor with the back towards a wall near a
socket. When selecting the location, keep in mind that once it has fi nished cleaning,
the robotic vacuum cleaner must have an unobstructed path back to the charging
station. There must be approx. 1.5 to 2 m of free space in front of the charging
station; there should be no furniture or other obstacles within this space. The sensor
must not be covered. No refl ective objects (e.g. mirrors) should be behind or next to
the charging station as they could confuse the sensor .
Connect the mains adapter cord to the charging station and then insert the mains
plug of the mains adapter into an easily accessible socket.
Charge the rechargeable battery
Discharge the rechargeable battery every few months and then recharge it. To
discharge the rechargeable battery, use the device with the charging station
disconnected from the mains so that it runs out of power. Then recharge the
rechargeable battery.
The device will indicate whether the rechargeable battery is fully charged, half
charged or almost empty. When in operation, the start/pause switch will either light
up in blue (rechargeable battery fully charged), pink (rechargeable battery half
charged) or red (rechargeable battery nearly empty).
You can determine the charge level of the rechargeable battery using the indicator
light on the charging station: If the indicator light is red, the rechargeable battery
is still charging; if it is fl ashing, the device is ready for use.
Before fi rst use or if the device has not been used for a prolonged period of time, it
will take approximately 6 to 8 hours for the empty rechargeable battery to
recharge; subsequent charge times will then range from approx. 3 to 4 hours. The
Содержание H-VCRX50
