Hyundai H-LCD1910, Инструкция по эксплуатации

Страница: 12 / 27

12 13
General information General information
Troubleshooting
Below is a table describing simple measures that can help you eliminate most problems likely
to emerge when this unit is in use. If below measures do not help, turn to a service center or to the
nearest dealer.
Symptom Cause Solution
No picture, no
sound, and no
indicator light
The power cord is not plugged in.
Contrast, brightness, sharpness, color
and volume are all in the minimum
value or TV is in mute mode.
Plug the power cord in.
Alter the value of contrast,
brightness, sharpness, color and
volume.
Picture and
sound with
abnormity
Contrast and color are set improperly.
Color system is set improperly.
Sound system is set improperly.
Set the value of Contrast and color
properly.
Set the sound system properly.
Picture is spotted
or with snow
Signal source is low-grade or the
signal is in a lower quality.
Use the qualified signal cord.
Blue background No video signal or the signal cord is
improperly/not connected.
Connect the signal cord properly.
No sound No audio signal or the signal cord is
improperly/not connected.
Connect the audio signal cord
properly.
Set the sound system properly.
The RC does not
work
Batteries are improperly installed or
exhausted.
Make sure the positive and the
negative polarities are correct.
Reattach the battery lid.
Replace the batteries.
Causes of interference
Incorporated in your TV receiver are
the most up-to-date devices to eliminate
interference. Local radiation however, can
create disturbances, which visibly affect your
picture. Proper installations, a good aerial
are your best safeguards against these
disturbances.
• RF INTERFERENCE: Moving ripples
across the screen are caused by nearby
transmitting or receiving short-wave radio
equipment.
• DIATHERMY: Herringbone pattern
and partial picture loss can result from the
operation of diathermy equipment from a
nearby doctor’s surgery or hospital.
• SNOW: Weak TV signals from long
distant stations result in an instead picture
and give the effect of falling snow. An antenna
adjustment or antenna amplifier may be
needed.
• GHOST: Multiple image, caused by
TV signals reflected back from surrounding
buildings, hills, aircraft, etc. is minimized by
correct aerial positioning.
• CAR IGNITION: Nearby cars and electrical
motors can cause small streaks across the
picture or make the picture roll.