Hyundai H-HI1-10-UI580, Инструкция по эксплуатации

Страница: 7 / 52

7.
Gas forced heater
EN
21. Use the heater only as described in this Manual. Any other use not recommended by the manufac-
turer may lead to fire, or injuries of people.
22. Never clean the heater, when it works. Do not submerge the heater into water.
23. It is prohibited to install the appliance immediately under an electric socket or under a wired
electric cable, when the output heat flows get to them. This may result in their overheating causing
an emergency situation.
24. Install and operate the appliance in strictly vertical position. It is prohibited to operate the appli-
ance in horizontal or inclined positions.
25. Do not take any action that could ignite the fuel gas.
26. Do not operate any electrical switches.
27. Do not pull any power supply or extension cords.
28. Do not light matches or any other source of flame.
29. Get everyone out of the building and away from the area immediately.
30. Close all propane (LP) gas tank or cylinder fuel supply valves, or the main fuel supply valve located
at the meter if you use natural gas.
31. Propane (LP) gas is heavier than air and may settle in low areas. When you have reason to suspect
a propane leak, keep out of all low areas.
32. The appliance is not designed for use by people (including children) with limited physical, sensory,
or mental capabilities and having insufficient experience/knowledge, if they are not supervised and
instructed on use of the device by a person responsible for their safety. It is necessary to watch that
children do not play with the heater.
Minimum distances for placement of the appliance
ATTENTION!
Disregard of the safety precautions and this instruction manual
supplied with the heat source can cause severe injury, death or
damage to Your property from the hazards of operation, fire,
explosions, burns, suffocation products of combustion or gas, and
electric shock.
To operate this device can a people that is able to read, understand
and follow all the instructions described in this manual manufacturer.
Fig. 2