3- 10
WHAT TO DO IN AN EMERGENCY
D060H02A-AAT
7. Re-install Wheel Nuts
To reinstall the wheel cover, hold it on
the studs, put the wheel nuts on the
studs and tighten them finger tight.
The nuts should be installed with their
small diameter ends directed inward.
Jiggle the tire to be sure it is completely
seated, then tighten the nuts as much
as possible with your fingers again.
WARNING:
Wheel and wheel covers may have
sharp edges. Handle them carefully
to avoid possible severe injury.
Before putting the wheel into place,
be sure that there is nothing on the
hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against
the hub. If there is, remove it. If
there is not good contact on the
mounting surface between the
wheel and hub, the wheel nuts could
loosen and cause the loss of a
wheel. Loss of a wheel may result in
loss of control of the vehicle. This
may cause serious injury or death.
!
HTB227
with the studs and slide the wheel onto
them. If this is difficult, tip the wheel
slightly and get the top hole in the
wheel lined up with the top stud. Then
jiggle the wheel back and forth until the
wheel can be slid over the other studs.
HTB229
TBENG_3.P65
3/9/2005, 5:02 PM
10
Содержание Getz 2004
